How to Program a Ford Spare Key

A spare Ford key can prove to be useful for car owners. Ninety-four percent percent of car owners use only one key, so having a spare key is vital. Although most new vehicles come with two keys it is recommended to have an additional.

Repairing a Ford transit Key fob spare key

It can be very disappointing to lose a Ford car key. Not only is it a hassle to have to replace it but it can also be expensive. To ensure that your key is replaced properly, you will have to provide the VIN number as well as other documents to verify ownership. Ford locksmiths might not have the tools to reprogram your key so it can work with your vehicle.

A Ford spare key can be extremely difficult to repair. Repairs might require the assistance of the manufacturer, which could take up to a week. The best course of action is to contact the car's dealership. If you are covered by a warranty, the dealership might be able to fix your key at a lower cost.

If you have a non-transponder chip car key, the dealer can cut a replacement key for you. But, you must be aware that a ford key programmer dealership will charge you more to cut this type of key in the event that it hasn't been programmed. If the dealership isn't able to cut the key, they will have to take your vehicle to their workshop. A transponder chip car key will require a different programming. You can try an automotive locksmith to cut a key if the ford fiesta spare key dealer isn't able to cut a key. If you don't have one you could try calling your insurance company and ask whether they'll reimburse you for the new key.

Reprogramming a keyless remote entry device

There are a variety of steps to change the programming of the ford van key replacement keyless entry remote. First, make sure that the vehicle is not locked. Next, turn the ignition switch eight times from ON to RUN. Then press and hold the remote button. Within eight seconds, the vehicle should go through the lock/unlock cycle and the remote should be programmed.

To reset the car's programming by turning the ignition switch to "Off". Then, put the key into the ignition and wait a few seconds. Once the programming process is completed you should hear a lock sound. If it does, hold the buttons down for five seconds. Release them after 30 seconds. Repeat the steps if required.

The programming of the remote may be difficult following the replacement of the Ford key. A professional dealer can help you through the process of programming. This will eliminate the trouble of locking and unlocking manually the car. It will also ensure that the car's keyless entry feature will operate without any issue.

You can also program a spare car key by using another remote. Once programmed the spare key will cycle the door locks for 8 seconds, and then you can use the spare key. You can also keep a spare Ford key fob in the vehicle's center console pocket.

If your original fob is damaged, a spare key could be required. A spare key could be used to swap the batteries if the first one is damaged. Fortunately, most key fob batteries cost less and replaceable. Before replacing the battery, close all doors.

It is easy to reprogram the Ford keyless entry remote. If you're unable to program the remote by yourself or at an Ford dealership such as MacPhee Ford in Latham. Once the new remote fob is programmed to work, you can use it to remotely unlock your car.